Potential of acid activated clays in the clarification of menhaden stickwater

Abstract

The primary objective of this investigation was to determine the feasibility of using acid activated clays to clarify menhaden stickwater effluent. Experiments, such as physical and chemical properties determinations, effect of changes in pH and temperature and coagulation, and coagulation followed by clay treatment were also performed to study the separation of solids in stickwater.

Analysis of the stickwater showed that it contained 4.5% crude protein, 1.4% crude fat, 6.5% total solids, 1.13% ash and 93.1% water. At a wavelength of 575 um, the sample absorbed all the light and the percent transmittance was zero. When diluted 1:100 the percent transmittance was 0.39 at the same wavelength. Measured at 25°C the sample had a viscosity of 9.0 centipoises.

The results showed that the precipitation of fat increased with increasing temperatures, while the reverse was true for protein. A pH of 4.0 gave the maximum clarification at all temperatures employed. The viscosity decreased at pH values above and below the original pH of the sample.

Among the four different acid activated clays used in this study (trade names Supact‐150, Impact‐150, Impact‐12 and Impact‐1OORR), Impact‐150 was the most effective in protein and fat precipitation, and the degree of separation of these components increased by treating stickwater with a coagulant (aluminum sulfate) prior to treatment with acid activated clay.     

Factors Influencing the Emissions of Nitrated-Polynuclear Aromatic Hydrocarbons(Nitro-PAH) from Diesel Engines

The potential problem of 1-nitropyrene (1-NP) formation during filter sampling of diesel emissions from dilution tubes is assessed. Rates of formation are calculated using data generated from several independent filter exposure studies. A portion of the 1-NP (12% average) found in participates collected from light-duty (LDD) and heavy-duty diesels (HOD) was found to be due to formation on the filter under average sampling conditions of 10-15/1 dilution at 44°C with 3 ppm NO₂ for 23 min. On the average, the concentration of 1-NP in participates emitted from HDD is 16 times less than that found in LDD run under similiar transient conditions. The average emission rate of 1-NP generated from the LDD and HDD was 4.7 μg/km and 1.5 μg/km, respectively for the vehicles operating under Federal Test Procedure (FTP)-transient conditions. Under operating conditions which increase exhaust temperature (increased speed and load), the concentration of nitro-PAH is significantly reduced with a concurrent increase in the concentration of partially oxidized nitro-PAH and dinitro-PAH. The concentration of 1-NP in the particulates measured from HDD in these dilution tube studies (0.33-0.95 ppm, depending upon engine load) is comparable to that measured in highway tunnel experiments (0.54 ppm average).     

Hazardous Waste Minimization: Part Vii (B) Hazardous Waste Minimization within the Department of Defense

This article is a series of representative case studies of Department of Defense hazardous waste minimization. Each Military Department and the Defense Logistics Agency describe actual accomplishments. Areas covered range from production line modification to product specification change. These efforts are part of a Department of Defense plan composed of individual programs executed independently by each military service and defense agency.

Part VII of the hazardous waste minimization series appears in two separate installments: the first installment, Part VII (A), dealt with Department of Defense waste minimization efforts in vehicle repair operations, explosives manufacturing, and abrasive blasting processes; Part VII (B) covers shipboard mercury wastes, industrial chemical control, solvent reclamation, and hazardous property sales efforts.     

Mathematical models for accurate prediction of atmospheric visibility with particular reference to the seasonal and environmental patterns in Hong Kong

Atmospheric visibility impairment has gained increasing concern as it is associated with the existence of a number of aerosols as well as common air pollutants and produces unfavorable conditions for observation, dispersion, and transportation. This study analyzed the atmospheric visibility data measured in urban and suburban Hong Kong (two selected stations) with respect to time-matched mass concentrations of common air pollutants including nitrogen dioxide (NO(2)), nitrogen monoxide (NO), respirable suspended particulates (PM(10)), sulfur dioxide (SO(2)), carbon monoxide (CO), and meteorological parameters including air temperature, relative humidity, and wind speed. No significant difference in atmospheric visibility was reported between the two measurement locations (p > or = 0.6, t test); and good atmospheric visibility was observed more frequently in summer and autumn than in winter and spring (p < 0.01, t test). It was also found that atmospheric visibility increased with temperature but decreased with the concentrations of SO(2), CO, PM(10), NO, and NO(2). The results showed that atmospheric visibility was season dependent and would have significant correlations with temperature, the mass concentrations of PM(10) and NO(2), and the air pollution index API (correlation coefficients mid R: R mid R: > or = 0.7, p < or = 0.0001, t test). Mathematical expressions catering to the seasonal variations of atmospheric visibility were thus proposed. By comparison, the proposed visibility prediction models were more accurate than some existing regional models. In addition to improving visibility prediction accuracy, this study would be useful for understanding the context of low atmospheric visibility, exploring possible remedial measures, and evaluating the impact of air pollution and atmospheric visibility impairment in this region.     

An evaluation of legislative measures on electrical and electronic waste in the People's Republic of China

With the increasing number of recycling mishaps in connection with waste electronic and electrical equipment (WEEE) in the People's Republic of China, it is imperative that the handling and recycling of WEEE be sufficiently regulated in China. Regulations covering three major issues, namely, take-back issues, controls on hazardous substances in WEEE and the assurance of good environmental management in WEEE plants, were promulgated between 2006 and 2008. The evaluation in this country report shows that few of these regulatory measures have performed satisfactorily in terms of enforcement, of public acceptance and of environmental concerns. In brief, the take-back requirements and the associated financial responsibilities are only vaguely defined; the control on hazardous substances and the so-called "environmental expiry date" requirements cannot be properly enforced, and the resources needed to ensure the satisfactory enforcement of the environmental abatement and pollution control requirements in WEEE plants are overwhelming. In addition, the use of a "multiple enforcement body" approach to the control of hazardous substances in WEEE is an indication that the Chinese government lacks the determination to properly enforce the relevant legal requirements.     

Ambient Air Monitoring for Sulfur Compounds

The role of sulfur compounds in our environment has been the subject of much speculation during the past two decades. An evaluation of the effect of man-made contributions to the biogeochemical sulfur cycle requires a comprehensive examination of source magnitudes, atmospheric concentrations and removal processes. Many voids exist in our present knowledge of these parameters despite the contributions of numerous researchers. Adequate information is needed concerning the various forms of sulfur as well as other critical constituents which exist in our biosphere so that their interrelationship and role in the mechanisms of the sulfur cycle may be more fully understood.     

Methane biofiltration in the presence of ethanol vapor under steady and transient state conditions: an experimental study

Methane (CH₄) removal in the presence of ethanol vapors was performed by a stone-based bed and a hybrid packing biofilter in parallel. In the absence of ethanol, a methane removal efficiency of 55 ± 1% was obtained for both biofilters under similar CH₄ inlet load (IL) of 13 ± 0.5 g_CH4 m^?3 h^?1 and an empty bed residence time (EBRT) of 6 min. The results proved the key role of the bottom section in both biofilters for simultaneous removal of CH₄ and ethanol. Ethanol vapor was completely eliminated in the bottom sections for an ethanol IL variation between 1 and 11 g_ethanol m^?3 h^?1. Ethanol absorption and accumulation in the biofilm phase as well as ethanol conversion to CO₂ contributed to ethanol removal efficiency of 100%. In the presence of ethanol vapor, CO₂ productions in the bottom section increased almost fourfold in both biofilters. The ethanol concentration in the leachate of the biofilter exceeding 2200 g_ethanol m^?3 _leachate in both biofilters demonstrated the excess accumulation of ethanol in the biofilm phase. The biofilters responded quickly to an ethanol shock load followed by a starvation with 20% decrease of their performance. The return to normal operations in both biofilters after the transient conditions took less than 5 days. Unlike the hybrid packing biofilter, excess pressure drop (up to 1.9 cmH₂O m^?1) was an important concern for the stone bed biofilter. The biomass accumulation in the bottom section of the stone bed biofilter contributed to 80% of the total pressure drop. However, the 14-day starvation reduced the pressure drop to 0.25 cmH₂O m^?1.     

Prediction of the Fate and Transport Processes of Atrazine in a Reservoir

The fate and transport processes of a toxic chemical such as atrazine, an herbicide, in a reservoir are significantly influenced by hydrodynamic regimes of the reservoir. The two-dimensional (2D) laterally-integrated hydrodynamics and mass transport model, CE-QUAL-W2, was enhanced by incorporating a submodel for toxic contaminants and applied to Saylorville Reservoir, Iowa. The submodel describes the physical, chemical, and biological processes and predicts unsteady vertical and longitudinal distributions of a toxic chemical. The simulation results from the enhanced 2D reservoir model were validated by measured temperatures and atrazine concentrations in the reservoir. Although a strong thermal stratification was not identified from both observed and predicted water temperatures, the spatial variation of atrazine concentrations was largely affected by seasonal flow circulation patterns in the reservoir. In particular, the results showed the effect of flow circulation on spatial distribution of atrazine during summer months as the river flow formed an underflow within the reservoir and resulted in greater concentrations near the surface of the reservoir. Atrazine concentrations in the reservoir peaked around the end of May and early June. A good agreement between predicted and observed times and magnitudes of peak concentrations was obtained. The use of time-variable decay rates of atrazine led to more accurate prediction of atrazine concentrations, while the use of a constant half-life (60 days) over the entire period resulted in a 40% overestimation of peak concentrations. The results provide a better understanding of the fate and transport of atrazine in the reservoir and information useful in the development of reservoir operation strategies with respect to timing, amount, and depth of withdrawal.     

Efficacy of vermicomposting for recycling organic portion of hospital wastes using <Emphasis Type="Italic">Eisenia fetida</Emphasis>: standardization of cow manure proportion to increase enzymatic activities and fungal biomass

Hospital wastes are infectious wastes generated in hospitals and need to be disposed in such a way that they do not spread disease. In this experiment, 5, 10, 15 and 20% cow manure (CM) were mixed with hospital wastes (HW), and mixed wastes were subjected to vermicomposting. In control treatment, only HW was used for vermicomposting. Results suggested that significantly (P ≤ 0.05) higher total nitrogen content was recorded in vermicomposts when 10% or more CM was added to HW. Higher mineralization rate (decrease in C/N ratio) and cellulase activity is probably responsible for rapid organic matter decomposition (loss of total organic carbon). Ergosterol content i.e., total fungal biomass and cellulolytic fungal population were almost constant initially, but increased in the latter stage of vermicomposting. All the vermicompost samples, prepared in this experiment, showed the absence of coliform bacteria. Therefore, it could be concluded that 10% CM addition with HW was the most economical to obtain best quality vermicompost in terms of nutrient content and microbial status.